What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 25.06.2025 07:26
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
A fuse is a non-resetable over current circuit protector.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–14 [Omar Gharbi Omar Gharbi ]
An AC voltage/ current source, and an ac inductive load.
In schematic diagrams this is the symbol for a fuse:
The MOV will conduct when the voltage exceeds 50% of line voltage.
Because the load is inductive, the current lags the voltage.(by a bit).
[image of Common-mode choke]
Taylor Swift Dance Wedding Video with Travis Kelce Reveals Unmatched Vibe - Athlon Sports
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
eight
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–16 [ OO OLAOYE OYEBODE ]
A circuit breaker is similar, but is resettable.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
How Moderna Went From Pandemic Hero to Vaccine Victim - WSJ
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is 'the assistant's answer'
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
He then describes the function of a fuse.
But it can get overloaded, and no longer works.
UFC Baku cheater (and $100k ‘Fight of the Night’ loser) transported to local hospital - MMAmania.com
So, the voltage could go up to 500 volts, and the fuse will not open up.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
He then asserts :
What do you do to make yourself sleep early?
These devices are installed between the “hot” and “neutral” and protective ground.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
but this device (an Inductor) … impedes the rapid changes in the current.
The other is “what does a “fuse” do?”
Here is a simplified AC power diagram.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Police take back statement dismissing hate crime in gay actor’s killing - The Washington Post
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This one hit behind the barn.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
a photo is worth a thousand words.
He then describes Rainy Season and Lightning.
Investigative Reporters Sound the Alarm at Peabody Awards - Variety
[old diagram got deleted by accident]
Upvotes:
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
First Sentence:
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Now when you have a certain ac resistance, then a current flows in a loop.
nine
The third is lightning and “how it gets conducted into a home.”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
so, what happens?
One
This is the picture of an electronic coil of wire wound around a core of magnetic material.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
but I think this circuit , shows a few more pieces.
At one ohm, the resistor has a maximum of 1 watt power.
At least they know the answer if they wanted it.
This is where the MOV conducts again, and dissipated the energy.
It also is a device that limits the change in current flow.
The bolt then partially travels down the line to your home.
What is lightning?
It seems Mohan does not understand the difference between a comment and an Answer.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
(Dc diagram shown, AC is similar).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Edit 2024–10.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
I post the exact comment here.
This device then solves the entire problem.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There are three different concepts here that are getting confused.
There are two important concepts here.
Barnstars:
2024–10–10[John johnson John Johnson ]
For this case there are devices called Metal oxide varistors (MOV).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What does a fuse do?
the problem then depends on "how fast does the fuse operate?".
One is “what exactly is in a ‘surge protector’ ? ”
what exactly is a ‘surge’ protector?